Creality Ender 3 V2 Neo - Z-Offset

3d Printing
1

This is a quick guide on levelling the Creality Ender 3 V2 Neo - Z Offset.

  1. Preheat the PLA
  2. Auto home the head
  3. Move the X and Y offsets to 117.0
  4. Slowly move the Z offset to 0, keep an eye on the nozzle.
  5. Lower it into the negative, until it’s just above the plate.
  6. Slide a piece of paper underneath it so it just slightly scratches it, not pinches it.
  7. Re level all 4 corners for consistency.
  8. Recheck in centre again making sure scratching the paper.